C8 Corvette Front Lift Lowering Collar Shims (2020+)

The C8 Corvette Front Lift Lowering Collar Shims are designed for C8s already equipped with front lift lowering collars. Each 3/8-inch shim installs inside the lowering collar to raise the front of the vehicle back up 3/8 inch, allowing you to fine-tune ride height without removing the lowering setup entirely.
Key Features

3/8-inch ride-height adjustment
Designed for use with C8 front lift lowering collars
Installs inside the lowering collar as a support
Raises the front ride height approximately 3/8 inch
Ideal for fine-tuning aggressive lowering setups
Compatible with factory Front Lift
Compatible with MagRide and non-MagRide applications

Lowering collars are not included

Fine-Tune Your C8's Ride Height
These shims are particularly useful when combining 1-inch lowering springs with 3/4-inch front lift lowering collars. Instead of running the full approximately 1-3/4-inch drop, adding the 3/8-inch shim brings the setup to approximately a 1-3/8-inch drop, providing additional ground clearance while maintaining an aggressive lowered stance.
Installation
The shim installs inside the existing front lift lowering collar and acts as a spacer to raise the vehicle approximately 3/8 inch.
Estimated installation time: 3 hours
Installation difficulty is rated Moderate / Difficult. Professional installation and a post-installation alignment are recommended.
Vehicle Fitment
2020+ Chevrolet Corvette C8 with Factory Front Lift
Fits:

C8 Stingray
C8 Z06
C8 ZR1
C8 Grand Sport
Coupe
HTC (Hard Top Convertible)
MagRide and non-MagRide vehicles

Factory Front Lift is required.
Warranty
Lifetime Warranty for the original purchaser. Warranty is non-transferable and subject to applicable terms and conditions.